A single pack waterproof polyurethane adhesive
Australia’s answer to Gorilla Glue
Purbond is an adhesive supplied by
DRIVE Marine Services for bonding timber, semi-porous and non-porous surfaces. Once you have experienced it's superior adhesive qualities where a strong, waterproof bond is required you will throw glues like PVA and aquahere away.
Features of Purbond are:
-
High adhesive strength
-
No creep in stressed joints
-
Suitable for use on damp surfaces
-
Does not leave a glue line like PVA glues or Epoxy
-
Application is to one surface only, coverage 200 - 250 ml per square metre
-
100% waterproof, which with stands 72 hour boiling water test
-
Sets in 2 - 4 hours, fully cured in 24 hours
-
Invisible in close fitting glue lines
-
Contains no volatile or flammable ingredients
-
Sands easily and does not blunt cutting tools
-
Better Bond if moisture applied to surfaces being glued
-
Will gap fill but has no strenghth where gaps are present
-
Can be applied direct from the bottle
Purbond will stick to almost anything except poly plastics (although even this can be achieved if desperate, talk to us). It will successfully glue :
- Aluminium
- Rubber
- Timber including oily and oxidising timbers such as Teak, Huon Pine, Jarrah & Eucalypts.
- Foam
- Stainless steel and other metals
- Brick and Concrete
Most of the above require special techniques to achieve good results. Call us for advice on your unique requirements.
There are other Polyurethane Glues in the marketplace, but Purbond has the following advantages over them;
-
Known Manufacture Date marked on each container. - Polyurethane glues have a shelf life as plastic is not waterproof and over 18 months to 2 years moisture will permeate through the container and the glue will then quickly go off. Other brands do not have a manufacture date marked on each container. We always have fresh PURBOND available.
DO NOT BUY MORE PURBOND THAN YOU WILL USE IN 12 MONTHS.
- PURBOND has a chemical additive which allows it to glue exotic materials that the others will not touch. - That is why it is always important to wipe the surfaces being glued with a cloth dampened with water. - Try gluing some aluminium or stainless steel together in a lap joint without wiping a damp cloth over the surface. The joint will easily pull apart.
- PURBOND comes with a detailed Tips Sheet when purchased from us based on our practical experience. Also, we are only a phone call away for product support.
- PURBOND comes in sizes from 125ml to 200 litres. Therefore you only buy what you need and do not end up wasting product because it is too old and goes off.
Expanda-van-homes use purbond polyurethane adhesive to glue the specially manufactured wall and roof panels together. The techniques used are patented and PURBOND was selected after two years of testing as it proved superior in adhering the panels as:
- It will not melt foam
- Superior adhesion on aluminium and mild steel sheeting to foam.
- It will not creep. Therefore ensuring the panels will not delaminate during transportation to site.
Member
(02) 9533 5470